|
..........................
| |
Jet Power Chips and Control Modules for
GM-Ford-Dodge.
Plus PowerTech 6-Pack driver select performance, and all others...
|
JET GM Performance Programmer
The JET Performance Programmer lets you take control and
program your own vehicle computer to match your driving
style. JET’s exclusive Tri-Power tuning allows you to
program for performance using lower cost regular octane
fuel, or for optimal performance gains you can program
for midgrade or premium fuels. All three tuning modes
are designed to operate the engine at peak efficiency
based on the octane level being used to improve
horsepower and mileage. The advanced technology and
design of the JET Programmer gives you the ability to
modify air and fuel ratios, ignition timing, shift
points, shift firmness, speed limiter and rev limiter
settings. The programmer will also correct your
speedometer and turn off the ABS system trouble light if
you change tire size or gear ratios. Also includes a
built in scan tool to read and clear diagnostic trouble
codes when your check engine light comes on saving you a
costly trip to the dealer. The programmer simply plugs
into the vehicle's diagnostic port under the dash and
then the easy to use installation software allows you to
make your changes by answering simple yes or no
questions. Take the next step in performance tuning with
the JET Performance Programmer!
-Add up to 130 horsepower and 205 ft/lbs of torque!*
-Tri-Power performance tuning modes for regular,
midgrade or premium fuels
-Raise or lower top speed and rev limiter!
-Correct speedometer and turn off ABS light after making
gear ratio or tire size changes
-Modify transmission shift points and shift firmness**
-Read and clear factory diagnostic trouble codes (turn
off check engine light)
-Change electric fan turn on temperature
-Bypass computer aided gear selector in manual
transmissions
-User friendly programming procedure
-Available for most GM gas and diesel applications
Programming options will vary depending on application.
*GM diesel truck LLY motor
**Gas applications only
NEW! JET Performance Programmers for gasoline powered
applications now include a built in scan tool with live
data monitoring. This new feature allows real time
monitoring of several vehicle sensors for fine tuning
and troubleshooting. The following vehicle parameters
can be monitored with the scan tool function:
-Calculated Load Value
-Engine Coolant Temperature
-Short Term Fuel Trim 1 & 2
-Long Term Fuel Trim 1 & 2
-Manifold Pressure (MAP)
-Engine RPM
-Vehicle Speed
-Spark Advance
-Inlet Air Temperature
-Throttle Position
-02 Sensors Bank 1 & 2
-Mass Air Flow Value
-Live data monitoring is included on software versions
3.5-up
-The JET Programmer locks to your vehicle's VIN code and
stores the factory program in it’s memory so the vehicle
can be returned to stock at any time. You can program
your vehicle as many times as you want, but the
programmer cannot be used on more than one vehicle.
-Ford and Dodge applications coming soon!
|
|
|
|
)